9.26.2006

aft bulkhead location prep

The aft bulkhead gets mounted on ten tapered layers of Unidirectional glass. I cut them to length then wet them in individually to insure good saturation. Over this goes a 16 in. wide girth strip of 24oz./ft^2 triaxial glass. ( Farrier says that when using epoxy, it's ok to use 9 layers ) Wow....that saves me a few ounces. Maybe I could take an extra bottle of beer on board. Posted by Picasa

1 comments:

Unknown said...

american actually....but spending time in NZ I believe.