9.24.2006

bulkhead scribe tool

Here's a simple scribe tool that I use to mark the final fit demension of the bulkheads. I place the bulkhead where it's supposed to go; then I run this scribe and mark the bulkhead on both sides by keeping the block up against the inside of the hull. The small block of 3/4 in foam is the same thickness of the foam bulkhead mounting strips so once the bulkhead is cut along this line, the bulkhead will fit perfectly against the mounting strips. Posted by Picasa

1 comments:

Unknown said...

why didn't I think of that....scruffing around on my back trying to mark all those bulkheads was getting fiberglass down my collar.