9.03.2010

trampoline study

These days, knot-less dyneema netting seems to be all the rage for high performance multi hulls. The going rate for a couple of forward nets is about $2000.   In my attempts to decide which type of netting to use, I decided to do a quick mock up. I used common construction twine to determine how much webbing would be needed to sew a set of nets. The strings were set up to represent a hole size of 1.5 inches when using 1.5 wide polyester strapping. Next step will be to wind up all the string, measure the total length multiply the length by the cost per foot of webbing then multiply that by two to determine material cost.

9.01.2010

a foam core removal tool


 I designed and built a custom foam removal tool that allowed me to strengthen the edges of  the window openings.  This tool uses four water jet cut "blades" fastened to a spindle that has an aluminum hand grip on one end. This tool really works and removes the foam core while leaving the fiberglass edge reinforcement. 


 Since I was taking this photo with one hand, I was not able to show myself holding the aluminum support handle with my other hand.  With one hand on the drill and the other supporting the end, this tool does a fine job removing foam core. This open space will later be filled with a mixture of epoxy and glass microbaloons. The edges will then be covered over with a wrap of DBM tape. Once complete, polycarbonate glazing will be fastened along these reinforced edges. 

 here is the finished window opening after using the foam removal tool to create a  1 inch a deep foam free edge.    


8.29.2010


 I plotted the dimensions of the windows onto butcher paper.
 
 I then positioned these templates as described in the                                                                                                                           plans



 I spent a little time transferring the shapes onto the cabin sides markimg inch and a half offsets with a sharpy. I then spent and hour or two cutting the window openings using a carbide blade on a nice Bosch saber saw. Ian is correct in stating that the positioning of the windows is crutial to the overall characteristic look of the Farrier boat. I imagine round Popeye port hole would make for an interesting look but usually it's considered in poor taste to change the basic look of a licensed boat. Some people go as far as suggesting that you will burn in hell for eternity so I didn't want to risk it. I think they look pretty good. If it didn't blow the weight budget, I'd go with the 2 inch thick laminated bullet proof polycarbonaet for those coastal cruises off the coast of Somalia.