Creating the Anchor well compartment

Here's a photo taken from inside the forward starboard cabin. The larger opening will become the anchor well hatch

After cutting the anchor well hatch, I then installed the internal anchor well bulkhead. Rather than laying up all the seams at this point, I have found it easier to position the bulkhead where it needs to be, smooth out the fillet with strips of peel ply and just give the bulkhead a while to set itself in place.  Tomorrow, all I'll need to do is pull off the strips and tape all the seams with glass and epoxy.

I chose to create a single hatch opening for the anchor well on the starboard fore deck because the port side cabin has been built up as the kids room. A benefit from this is that the hatch can be hinged to lie flat on the fore deck when open. In this case, this offset compartment can be used for sail storage as well and anchor windlass operation.