5.29.2007

edge seam detail

Here's a shot of the edge seam detail

Posted by Picasa

Laminating the outside of the inner starboard hull section

Here's the inner starboard hull section dry fitted with a full length run of 34 oz. / yd ^2 triaxial glass. I measured and placed the glass cloth over the foam and held it in place with a few spring clamps along the upper edge. If you look closely, you can see the recessed strip that I cut in the foam with a power planer to allow the next run of glass cloth to lay flush along the seam and reduce the amount of exterior hull finish work. I chose NOT to cut the foam down on the inside.

Posted by Picasa