3.26.2007

two down.......

Two down...two to go......

The starboard inner hull half is now resting on the shop floor in a stable position. I managed this in about an hour by myself using a couple of chain lifts, some straps and a little bit of head scratching.

Posted by Picasa

lifting the sarboard inner hull half

After installing a few temporary supports and braces, the starboard inner hull half is ready to be rolled off the mold. Compared to the outer sections that include bulkheads and deck portions, the inner section is a lot easier to handle. It is however, a bit flexible in torsion at this stage.

Posted by Picasa